Day22

this is a part of the hand distance code, not too difficult other than the last problem. don't think i's working.

the input and output of the hands code. it seems like it's working well except problem 5.

the problem with the MPU lab was creating separate files. although it wasn't hard it just wasn't clear that i had to include 2 files.


Comments

Post a Comment

Popular posts from this blog

Day19

Image
the SD logging code modified to get temperature and read the data. The output was working in class , but the arduino doesn't want to run for some reason now. the code does work  if there is the speed.txt . the setup of the sd card reader and the i2c . wiring for general is sometimes confusing for me so this part took time from the wring.
Read more

Day7

Image
the code for the sound lab using the cheap speaker. as with all the labs and project using the speaker, trying to get the thin wires to get into the breadboard and having it stay there took the longest. the lecture code for the recursive and non-recursive code for factorials the output for the factorials. they both seem alright and bad. JDoodle did have a small cap so i think higher numbers just gets capped.
Read more

Day12

Image
the code using the I2C  temperature sensor and using the RGB LED to display the temperature. the code was easy , but the wiring was confusing. Trying to wire it correctly part of the problem to get it to work. this is before the lights were connected, and i was used on the lab. The pin that wasn't used threw me off on the wiring. The elevation code, but modified for the homework. This HW was fairly easy because it was just mainly creating loops and counters or copying and modifying the already existing loop. This code is actually from the final as i can't find the original code. the output of the elevation code. 
Read more